Formula and worked example
One roofing square is 100 ft² of roof surface, equivalent to 9.290304 m². Roofing squares = required roof coverage in ft² ÷ 100. Fractional squares represent continuous coverage and are not automatically rounded into a product order.
For horizontal projected area at a single pitch, slope factor = √(1 + (rise per 12 ÷ 12)²). Gross roof surface = projected area × slope factor. Net surface = gross roof surface − roof-surface exclusions. Required coverage = net surface × (1 + waste percentage / 100).
The starting 40 × 30 ft projection gives 1,200 ft². At 6:12 pitch, factor = √1.25 = 1.118033989. Gross surface is about 1,341.640786 ft². With no exclusions and the editable example 10% waste allowance, required coverage is about 1,475.804865 ft², or 14.75804865 roofing squares.
Choose the correct measurement basis
Horizontal projected area is the roof’s plan projection, including its overhangs. Interior floor area is not automatically roof projection. One common pitch applies to the entire projection entered. For a simple same-pitch gable, the full projection already represents both sides; do not double it again. Different pitches and overlapping/complex roof geometry need separate verified takeoffs.
Measured roof-surface mode uses actual sloped surface area directly, with no pitch adjustment. For a rectangular plane, use length × sloped surface width. For multiple planes, sum their gross surface areas separately and enter the result in known-area mode. Hidden pitch is ignored in measured-surface mode.
Independent 3–4–5 geometry example
A 9:12 pitch has rise/run = 3/4 and slope factor = 5/4 = 1.25. An 800 ft² horizontal projection therefore gives 1,000 ft² of roof surface. Deduct 40 ft² measured on that surface to get 960 ft² net. Add 10% once: 1,056 ft² required coverage, or 10.56 squares.
Metric equivalent arithmetic: 80 m² projected area at 9:12 gives 100 m² surface. Deduct 4 m² of roof-surface exclusions and add 10%: 105.6 m² required. Convert to ft² before dividing by 100 for roofing squares.
Exclusions, allowance and purchasing
Exclusions are actual sloped roof-surface areas, subtracted after pitch correction. Do not enter horizontal-projection deductions here. Enter zero for areas already deducted, or where your takeoff retains penetrations because material is still consumed around them. Exclusions must be smaller than gross surface area.
The starting 10% waste allowance is an editable arithmetic example, not a universal roofing specification. Use an allowance suited to the material and roof details; apply it once. This calculator does not estimate product-specific bundles, rolls, starter courses, ridge caps, flashing, fasteners, underlayment laps, costs or a whole-package purchase. Confirm the actual product’s coverage and order increments separately.
Units, validation and scope
Length selectors convert dimensions. The area selector retains numbers so known area and surface deductions can match their source units. Inputs accept finite decimals. Pitch accepts 0–120 rise per 12 as an input sanity range, not a recommended roof slope. Waste accepts 0–100%; surface and required coverage are capped at 1 billion ft². Displayed values use up to three decimals, or six for the factor, while calculations use unrounded values.
Zero pitch gives a factor of one geometrically; it does not establish drainage or material suitability. The estimate does not size structural members or approve an assembly. Roof area, roof shingles and roofing cost remain separate requested calculators.
Reference
GAF: How to Measure a Roofing Square defines the 100 ft² square and explains that slope and overhangs affect roof size. The slope multiplier used here follows right-triangle geometry; no product-specific bundle count is assumed.